Trinus is not a very good platform for laser engraving, and moer trouble than it's worth to make it both a 3D printer and laser engraver. Once you get the printer working, you can build a dedicated laser gantry from one of the designs available on Thingiverse. Using Repetier firmware is also possible.ĭon't bother with the laser. This is needed when you perform step 2.įor slicing, you can use Ultimaker CURA if you want to print from SD card or via OctoPI, or use Repetier Host if you like to print direct from PC. This reduces strain on most of the cables. Link below.įlip the controller 180 degrees, so all connectors come out of the top. You will lose the use of the LCD display, but gain so much more. There are a few things you can do to make it more reliable, and easier to get support for. Arguably it is a 3d printer with promise, but was poorly executed by the company. For anyone stumbling onto this thread, I can help you make the best of your Kodama Trinus.
0 kommentar(er)
